Public Forums
General Discussion
All general information. This is a public forum.
- Threads
- 176
- Messages
- 822
Brewing Questions
General Brewing Questions - discuss Extract/All-Grain, recipes, equipment questions, etc.
- Threads
- 53
- Messages
- 404
Off Topic Discussions
Publicly accessible Off Topic discussion area.
- Threads
- 42
- Messages
- 264
Public Homebrew and Craft Beer Events
Cool Homebrewing and Craft Beer Events coming up. Wnat to promote Big Brew Day, or Teach a Friend to Homebrew? Hear about a special Bottle Release? Questions about a Beer Festival? Post all here.
- Threads
- 64
- Messages
- 246
Forum statistics
Latest profile posts
Eric Stephenson wrote on Ryan P. Egan's profile.
Hey Ryan,
Just rejoined the club ... went to the meeting at CKBC tonight ... starting brewing again a couple of weeks ago. Hope to see you at an meeting soon.
Eric
Just rejoined the club ... went to the meeting at CKBC tonight ... starting brewing again a couple of weeks ago. Hope to see you at an meeting soon.
Eric
Hey folks. Looking for some feedback/experience in using fresh cranberries versus cranberry juice concentrate for a Cranberry Orange IPA
Kristina Nasuti wrote on Chris Smith's profile.
Hey, Chris.
I recently paid the membership dues and would like access to the private forum.
Since I'm new to the group, I wasn't sure if there's anything else (other than paying yearly dues) that I need to do to become a member.
Cheers,
Kristina
I recently paid the membership dues and would like access to the private forum.
Since I'm new to the group, I wasn't sure if there's anything else (other than paying yearly dues) that I need to do to become a member.
Cheers,
Kristina
Michael McClernan wrote on John Eaton's profile.
John,
It's been a while, but do you still have sets of o-rings for ball lock posts & disconnects. I'm getting ready to place an order with McMaster, and wanna try to them for lid gaskets and tubing. If you still have these sets available I'd like to pick some up. Otherwise I'll order from McM. Let me know. Thanks
It's been a while, but do you still have sets of o-rings for ball lock posts & disconnects. I'm getting ready to place an order with McMaster, and wanna try to them for lid gaskets and tubing. If you still have these sets available I'd like to pick some up. Otherwise I'll order from McM. Let me know. Thanks